Specifications Chart - Briggs & Stratton Vanguard Fi3.8 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Specifications

Specifications Chart

Nominal Voltage
51.6V
Top Voltage
58.8V
Cut-off Voltage
35.0V
Discharge Temperature
-4°F to +140°F (-20°C  to 60°C)
Range
Storage Temperature 1
-4°F to +140°F (-20°C to +60°C)
month
Storage Temperature 1 year -4°F to +77°F (-20°C  to +25°C )
Charging Temperature
14°F to 113°F (-10°C to 45°C)
Range
Maximum Heat Exposure
158° F (70°C)
IPX Rating
IP67 + Pressure Wash
Battery Terminal Torque
55 in-lb (6.21 Nm)
Hazardous Material
Class 9
Classification
Compliance
FCC Compliant
Pursuant to part 15.21 of the FCC Rules, you are cautioned that changes
or modifications to the product not expressly approved by Briggs & Stratton
could void your authority to operate the product.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
5

Publicidad

Tabla de contenido
loading

Tabla de contenido