Log Splitter Operation; Freeing A Jammed Log - EarthQuake 32228 Manual De Propietario

LOG SPLITTER OPERATION

The Earthquake® 5-Ton Electric Log Splitter requires the use
of both hands to operate. The user's left hand controls the
hydraulic control lever, while the right hand controls the
push button switch. The log splitter will freeze upon absence
of either hand. The log pusher will return back to the starting
position only after both hands release the controls. (SEE
FIGURE 4)
Split the log in the direction of its grain. Placing logs across the
log splitter for splitting is dangerous and may seriously damage
the machine. Do not attempt to split two logs at the same time.
hydraulic
contol lever
Figure 4

FREEING A JAMMED LOG

1. Release both controls.
2. Once the log pusher completely stops at its starting
position, insert a wood wedge under the jammed log.
(SEE FIGURE 5)
3. Start the log splitter to push the wood wedge under the
jammed log.
4. Repeat above procedure with sharper sloped wood
wedges until the log is completely freed.
Figure 5
8 Get parts online at www.GetEarthquake.com or Call 800-345-6007 M-F 8-5 CST
push button
switch
CAUTION
NEVER FORCE PRESSURE ON THE LOG SPLITTER
FOR MORE THAN 5 SECONDS IN ORDER TO SPLIT
EXCESSIVELY HARD WOOD.
CAUTION
ALWAYS SET LOGS FIRMLY ON THE LOG CRADLE AND
WORK TABLE. MAKE SURE LOGS WILL NOT TWIST,
ROCK OR SLIP WHILE BEING SPLIT. DO NOT FORCE
THE WEDGE BY SPLITTING THE UPPER PART OF THE
LOG. THIS WILL BREAK THE WEDGE OR DAMAGE THE
MACHINE. (SEE FIGURE 6)
CAUTION
DO NOT TRY TO KNOCK THE JAMMED LOG OFF THE
WEDGE USING A HAMMER OR OTHER DEVICE. (SEE
FIGURE 7)
Figure 6
Figure 7
Owner's Manual
5-TON ELECTRIC LOG SPLITTER