Product Operation - Marshalltown PRO 36 Manual Del Propietário

1. Adjust the cutting wheel setting to the highest
position which still makes firm contact with the tile
when you press down on the handle. It is a good
idea to test your setting with a scrap tile to get the
feel for the pressure required to cut.
3. Place the cutting wheel on the rear edge of the tile
and slide the wheel forward by pushing the handle
down, scoring the tile as the handle is pushed
forward. It is important to make this scoring cut in
one continuous motion, scoring only once per tile.
WS2734revA
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com

PRODUCT OPERATION

2. Adjust the protractor gauge for the proper tile size
and place the tile to the most forward position of
the cutter against the stop.
4. After scoring, and without moving the tile, position
the handle so that the breaker foot is directly above
the tiles front edge (at the stop). Apply increasing
pressure on the handle until the tile snaps along the
score line.
5 of 8