NuWave OXYPURE ZERO Manual Del Propietário página 21

Do not dry the filters in direct sunlight or with a hot blow dryer. Do
not use a vacuum cleaner or too stiff a brush to clean the Bio-Guard
filters or Prefilters.
To Clean the Bio-Guard
1. Remove the filters and immerse them in water.
2. Spray the filters with a mild detergent and let them sit for 2 – 3 minutes.
3. Submerge the filters in warm water, shake, and remove. If you cannot
fully submerge the Bio-Guard
pressure running water.
4. Repeat this process until the filters are clean.
5. Rinse the filters with warm water (see 3 above).
6. Dry the filters completely, out of direct sunlight, before use.
Clean the Bio-Guard
cleaner will only put the captured particles, allergens and pathogens back
into the air.
To Clean the Ozone Emission Removal Filters
1. Remove the filters. If possible, take them outside to clean.
2. Gently, but thoroughly, clean the filters using a brush-tipped vacuum.
3. Repeat the process on the other side. DO NOT GET WET.
To Clean the Stainless-Steel Prefilters
The Prefilters need to be cleaned at least once every two months,
depending on use. Begin by immersing the Prefilter in water. Then:
1. Use a dry cloth or soft brush to remove any dust or lint.
2. Clean the filters with warm soapy water.
3. Rinse the filters thoroughly and remove any soap particles.
4. Allow the filters to dry completely, out of direct sunlight, BEFORE
reinstalling them in the OxyPure (up to 12-24 hours).
Filters
®
360 Filter, then place it under low-
®
CAUTION
filters IN WATER ONLY. Using a brush or a vacuum
®
®
nuwavenow.com
21