Maintenance/Replacing Consumables - TCL Sweeva 100 Manual

5. Maintenance/replacing consumables

◆
1. Cleaning of dustbin and filter net (filter net is replaceable)
Please power off the power before maintenance
Note: Please turn off the power (bottom rocker switch)of the robot before product maintenance
/replacing consumables.
The suction power may become weak if the dustbin is full. The dustbin needs to be cleaned
before and after each cleaning.
①
Press the buckle of the dustbin with your thumb, and drag the dustbin out.
(When taking out the dustbin, do not turn it upside down) Hold the dustbin up and down with both
hands, and open the dustbin forcefully;
Hold the dustbin with your left hand, tilt it at a suitable angle, and use the cleaning tool with your
right hand to pour out the dust in the dustbin;
④
Hold this position with your thumb to the left and pull up the filter;
⑤
Rinse the dustbin and filter(not frequently, monthly cleaning is recommended), wash for at least
1 minute, and shake off the water drops. Please wait until the dust bin and filter are completely
dried(≥24h) before using it, to ensure their service life.
⑥
Filter installation/new filter net replacement: Insert the filter net into the housing slot, and then
fasten the filter downwards until it buckles into place.
- 11 -
EN