Tools Required - Whittier Wood Products 725W Hoja De Instrucciones

725W Open Media Cabinet — Parts List
M — Tack Glide — Qty. 2
P — #8 x 5/8" Pan Head Screw — Qty. 8
ASSEMBLY INSTRUCTIONS
Phillips Head and Slotted Screwdrivers, Hammer, Tape Measure.
IMPORTANT:
We recommend finishing the unit before final assembly. Before finishing, read enclosed finishing hints.
NOTE: Due to the fact that more than one type of hardwood is used, we recommend testing for desired color.
To test for desired color on:
a) Veneer parts—apply stain to unexposed portion of side panel. See FIGURE 1.
b) Alder pieces—apply stain to back of base. See FIGURE 5.
NOTE: In an effort to control costs and preserve natural resources, we remanufacture some components, cutting
them into smaller parts to eliminate the defects. This may result in some holes or grooves appearing in inconspicuous
locations such as the bottom of the bottom shelf. These extra holes should be disregarded in assembling your
product.
I
FIG. 1
I
Stain Test
Area
Bottom
TO ASSEMBLE THE MAIN UNIT:
1) Place the Right Side Panel (A) on the clean carboard inside the box or on a carpeted surface with the
holes pointing upward. Screw Cam Connectors (I) in the two pre-drilled holes at the bottom. See
FIGURE 1. Now screw the cam connectors into the pre-drilled holes in the bottom of the Top Shelf
(C[a]).
Do not over-tighten and thus imbed the shoulder of the cam connector into the wood. The
shoulder should be flush or just in contact with the surface of the wood as shown in FIGURE 1a.
Repeat step one on the Left Side Panel (B).
All manuals and user guides at all-guides.com
N — Adjustable Glide — Qty. 2

TOOLS REQUIRED:

C[a]
Holes for adjustable shelves.
A
O — Corner Brace — Qty. 2
Q — #6 x 3/8" Brass Screw —Qty. 12
I
The side panels have a compression
stamp on the bottom edge:
FIG. 1a
Shoulder must be
flush with the wood!
Top
DO NOT IMBED THE SHOULDER INTO THE WOOD!
(cont.)
"L" for left, "R" for right.
I
725W — Page 3