Operating Instructions - Newlux SecaDry v150 XXL UV Manual Del Usuario

OPeRatinG inStRUctiOnS

1. Connect the supply plug to the electrical current, more than 10A.
2. Place the items of clothing on the shelfs, which have firstly been
wrung out and are not dripping. Close the outer cover.
1H DEfAULT MODE: After connecting the cable, the machine will be
in standby mode, the standby light will turn on, press the ON switch
to turn on the device. The default time is one hour in dry mode, the
"1 hour" light will flash 15 minutes before the dry mode ends. The UV
sterilization light will turn on and the UV lamp will start operating until
the end of the dry mode.
2H DRYING MODE: Press the ON switch twice, the machine will start the
2 hour dry mode. The "2 hours" indicator light will flash for the last 15
minutes of the dry mode. The UV sterilization light will turn on and the
UV lamp will start operating until the end of the dry mode.
3H DRYING MODE: Press the on switch three times, the machine starts
the 3 hours dry mode, the "3 hours" light flashes for the last 15 minutes
of the dry mode, the UV sterilization lamp turns on and operates until
the end of the dry mode.
STERILIZATION MODE: Press the on switch four times and the machine
will start the 30 minute UV sterilization mode independently. The
"Sterilization" lamp will flash, at this time the PTC heater and fan will not
operate, the UV lamp will operate until the end of the 30 minute period.
SAfETY SYSTEM: When the UV lamp is in operation and someone
approaches the machine by the front side within a range of 2 meters,
the UV sensor will be activated and the UV lamp will immediately turn
off automatically. When the person leaves or moves away from the
detection range, the UV lamp will turn on and start operating again
after 10 seconds.
| 22
UV lamp
Sterilization working status light
Time
Power ON/OFF Switch
UV Sensor