Pahlen LED 170ML Manual Del Usuario página 9

Light unit LED 170ML
Start Up
First check that the lights are installed correctly.
OBS! The lights should be completely covered by the water before they come on.
Manual Sync:
1. Activate the synchronization of the multi-coloured lamp programs by switching on the lights, check if all lights come on, wait
for a few seconds.
2. Switch off the lights and wait for at least 9 seconds, then switch them on again.
3. Replace the program twice by switching on and off the lights. Now all lamps are in the same program mode.
4. When the lights are synchronized keep their setting until a light is replaced or switches off separately.
Manually changing the colour/programs:
Replace the program mode by rapidly switching on and off the lights again (max 10 seconds). The lights shift to the next program (1-16, see below).
Store the last colour/program:
Select the desired colour/program. Turn the lights off, wait at least 12 seconds. The selected program is now stored.
Program Name
1. Sun white
2. Red
3. Green
4. Blue
5. Green-Blue
6. Red-Green
7. Blue-Red
8. Evening by the ocean
9. Evening by the river
10. The Riviera
11. Neutral white
12. Rainbow
13. Flood of color
14. Disco
15. Four season
16. Party
Frost Risk
Always power off the lamps before a possible winter closure. The light source shall be protected against ice. For the lights not to
freeze, we recommend doing the following:
1. Loosen the front ring.
2. Unclip the lightning element from the gasket.
3. Let the light gently fall to the bottom of the pool (hanging in the cable) where the water does not freeze.
Troubleshooting
Problems Solutions
Lights indicate dif- Check that all lights are correctly connected to the same transformer and via the common power
ferent switch according to the schematics.
colour/program Carry out synchronization under "Manual sync" above.
Flickering or glowing • Check that all cables are properly connected.
light
• Check that the cables/connections are not damaged.
• Check that the cable between the light and the transformer is correctly dimensioned (see table).
• Check the voltage at the transformer. It should be between 12VAC and 13VAC. Check that the trans-
former has sufficient capacity to operate all connected lights.
If the transformer's voltage is fine, a thicker cable may be needed between the transformer and light.
Feature Colour
Fixed Warm white
Fixed Red
Fixed Green
Fixed Blue
Fixed Green - blue
Fixed Red - green
Fixed Blue - red
Slow shifting Red - bluet
Slow shifting Red - green
Slow shifting Green - blue
Fixed Cool white
Slow shifting Blue - red - green
Slow shifting Program 12 followed by program 15
Fast shifting All colours
Slow shifting Red - blue - green - purple
Fast shifting All colours
9
ENGLISH