Troubleshooting - NewAir NPR122GA00 Manual Del Propietário

TROUBLESHOOTING

Problem
Refrigerator does
not work
Refrigerator
compartments are
too warm
Food is frozen
There is a "water
flow" noise from
inside the fridge
There are
waterdrops around
the refrigerator
casing or door gap
The compressor is
slightly noisy when
starting
Code F1 displayed
Code F2 displayed
Code F3 displayed
Code F4 displayed
Code F5 displayed
www.newair.com
Solution
Check if the switch is on.
Check if the plug and socket are connected well.
Check if the fuse has been burnt.
Check if the power supply is malfunctioned.
Switching on/off the fridge frequently may cause start
delay of the compressor.
The door is opened frequently.
A large amount of warm or hot food was stored
recently. Wait for the refrigerator to reach its selected
temperature.
The refrigerator has been disconnected for a period of
time.
The temperature was set too low, please increase the
temperature.
I t' s a normal phenomenon, caused by the flow of
refrigerant.
It' s a normal phenomenon, the moisture will
condense to water when it touches a cold surface of
the refrigerator.
It' s a normal phenomenon the noise will be reduced
after the compressor works stably.
Possible cause: low voltage to fridge.
Adjust the battery protection from H to M or from M
to L.
Possible cause: condenser fan is overloaded.
Disconnect power to fridge for 30 minutes& re-start.
Possible cause: the compressor starts too frequently.
Disconnect power to fridge for 30 minutes& re-start.
Possible cause: compressor not kicking in. Disconnect
power to fridge for 30 minutes & re-start.
Possible cause: overheating of the compressor &
electronics. Disconnect power to fridge for 30 minutes
& re-start.
EN
16