Installation Of Removable Switch Housing - Hinkley BIMINI Manual De Instrucciones

INSTALLATION OF REMOVABLE SWITCH HOUSING

Mounting Plate
Fig. 1
NOTE: Be sure the power is off before installing.
1 Remove one of the three screws on the mounting hub
located on the fan motor. Loosen the other 2 screws. (Do not
remove) (Fig. 1)
2
Place the key holes on the mounting plate over the 2 screws
previously loosened, turn the mounting plate until it locks in
place at the narrow section of the key holes. Secure by
tightening the 2 screws previously loosened and the one
previously removed.
Remove one of the three screws on the mounting plate
3
located on the fan motor. Loosen the other 2 screws. (Do not
remove) (Fig. 2)
Mounting Hub
(bottom of motor)
Screws
5
Wire Connectors
Detachable
Switch Housing
Fig. 2
4 Connect the plug and receptacle and make sure side buckle
snaps in place. (Fig. 2)
Tuck connections neatly into mounting plate. Place the key
5
holes on the light kit over the 2 screws previously loosened,
turn the light kit until it locks in place at the narrow section of
the key holes. Secure by tightening the 2 screws previously
loosened and the one previously removed.
6
Attach pull chain fob to end of the switch's pull chain.
7 Restore power and your light kit is ready for operation.
Mounting Plate
Screws
©2019 Hinkley Lighting, Inc. | hinkley.com |
11