Technical Data; Adjusting The Volume; Safety Advice - Fontastic Shagi+ Manual Del Usuario

GB
Transparent Mode: Tap and hold the multifunction
sensor on the right headset for 2 seconds to activate
Transparent Mode. When activating the transparent
mode. The ambient noise is transported directly into the
loudspeakers of the headsets. Thus, the ambient noise
can be perceived better.
ANC mode: Tap and hold the multifunction sensor on
the right headset again for 2 seconds to activate active
noise cancellation. By activating ANC mode, some
ambient noise will be suppressed.
Normal mode: Tap and hold the multifunction sensor on
the right headset for 2 seconds again to switch back to
Normal mode.
Music mode
Tap and hold the multifunction sensor on the left
headset for 2 seconds to activate music mode.
Gaming Mode: Tap and hold the multifunction sensor
on the left headset for 2 seconds to activate Gaming
Mode. This lowers the latency so that the transmission
is less than 60 ms and gaming or TV is possible without
audible delay.
Voice assistant
Tap the multifunction sensor on either headset unit three
times to activate the voice assistant.

Adjusting the volume

The volume is adjusted via the Bluetooth source.
Note: In rare cases, the super bass of the headset
may be overdriven by the settings of the mobile phone.
In this case, use the „Normalise" function (also „Adjust
volume") in the audio settings of your phone.

Safety advice:

• Do not use the headset at high volume for prolonged
periods of time.
• Be careful not to use headset in potentially dangerous
situations.
• Do not use the headset while operating a vehicle.
• Never open the device.
• Never immerse the device in water, always protect it
from moisture.
5
• Disconnect electronic devices from the power when
not using them for longer time.
• Do not use headphones if they show any visible
damage.

Technical data:

• BT Version 5.3
• Profiles: HS, HF, A2DP, AVRCP
• AAC Audio Decoding
• Active Noise Cancelling, up to -30 dB
• Range: Up to 10 m
• Driver diameter: 13 mm
• Sensitivity: 115±3.0dB
• Frequency response:20Hz-20KHz
• Speaker impedance: 32Ω ± 15%
• Built-in high-performance microphone
• Operation time: 7 hours each time
• Battery Headset: 40 mAh
• Battery Charging Box: 300 mAh
• Dimension Headset unit: 36.3 x 20.9 x 24.7 mm
• Weight per Headset unit: 4.5 g
• Dimension Charging Box: 62.8 x 50.8 x 27.3 mm
• Weight Charging Box: 39.5 g
The company is not responsible for any damage due
to improper operation.
If you need technical support, please contact our sup-
port team by e-mail at service@fontastic.eu.
We hereby declare, that this device carries the
CE mark in accordance with the regulations
and standards. It conforms with the fundamental
requirements of the (RED) 2014/53/EU directive.
The full text of the EU Declaration of Conformity is
available at the following Internet address
www.d-parts.de/Konfo
GB
6