Assembly Instructions - Kobalt KLB 1040B-03 Manual Del Usuario

ASSEMBLY INSTRUCTIONS

1. Assembling the Blower Tube
This product requires assembly before using.
WARNING
• To prevent accidental starting that could cause
serious personal injury, always remove the
battery pack from the tool when assembling
parts.
a. Align the groove in the blower tube (E) with
the knob on the blower housing. Push the
tube onto the blower housing until it snaps into
place (Fig. 1a). Pull on the tube to ensure that
it is securely attached to the blower.
b. To remove the tube, press and hold down the
tube-release button (F) and then pull the tube
straight from the blower (Fig. 1b).
2. To Install/Remove Battery Pack
To Attach Battery Pack
Make sure that the variable-speed trigger switch
(A) is in OFF position and the trigger-lock lever (C)
is in OFF position.
a. Align the mounting grooves on the battery
pack with the raised ribs in the blower's
battery port, as shown.
b. Slide the battery pack into the blower until it
snaps into position.
NOTICE: Make sure that the latch on the blower
snaps into place and the battery pack is secured
to the blower before beginning operation. Improper assembly of the battery pack can cause
damage to internal components.
1a
E
1b
2
C A
8
Knob
F
1
2
Battery-release
button