universalblue UECGDWHITE-19 Manual De Instrucciones página 33

Burner Nozzle Replacement
Loosen the nozzle gently with a wrench (7).
Insert the new nozzle, make sure it is suitable for
the type of gas required (refer to the previous
table for reference)
After you have converted the unit to a different
type of gas, be sure to place a label with the
corresponding new information on the unit.
CONVERT THE GAS SOURCE
Adjustment of the reduced valve flow
Burners Flame
Full
flame
Regular
burners
Saving
flame
Adjusting the valve
Valve adjustment should be done with the control knob set at Burner ON saving flame
position.
Remove the knob, and adjust the flame with a tiny screwdriver (see fig.7 below).
To check the adjusted flame: heat the burner at full open position for 10 minutes. Then
turn the knob into the saving setting. The flame should not extinguish nor move to the
nozzle. If it extinguish or moves to the nozzle, readjust the valves.
Converting the hob from LPG
to natural gas
Replace the burnerNozzle
according
To the guidelines intable 1
Loosen the adjustment Spindle
(see fig.7 below ) and adjust the
flame
Converting the hob from natural
gas
Gas to LPG
Replace the burner Nozzle
accordingto the guidelines in
table 1
Loosen the adjustment Spindle
(see fig.7 below ) and adjust the
flame
33