Berner BSC 1.7 Manual Original página 20

OBJ_BUCH-0000000351-002.book Page 20 Monday, April 1, 2019 2:55 PM
20 - English
Notes on sawing chassis sections.
Select a high oscillating frequency. Round saw blades can
be released and clamped offset again, to allow for uni-
form wearing off.
Notes on scraping.
Select a moderate to high oscillating frequency.
Repair and customer service.
When working metal under extreme operat-
ing conditions, it is possible for conductive
dust to settle in the interior of the power tool.
The total insulation of the power tool can be impaired.
Blow out the interior of the power tool via the ventila-
tion slots frequently with dry and oil-free compressed air,
and connect a residual current device (RCD) on the line
side.
When the power tools's power supply cable is damaged,
it must be replaced using a specially prepaired power sup-
ply cable, available from your Berner customer service
agent.
Products that have come into contact with asbestos may
not be sent in for repair. Dispose of products contami-
nated with asbestos according to the applicable country-
specific regulations for such disposal.
The current spare parts list of this power tool can be
found on the Internet under www.berner.eu.
If required, you can change the following parts yourself:
Application tools
Declaration of conformity.
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standarisation documents:
EN 60745-1:2009 + Cor.:2009 + A11:2010
EN 60745-2-4:2009 + A11:2011
EN 60745-2-11:2010
EN 55014-1:2017
EN 55014-2:2015
EN 61000-3-2:2014
EN 61000-3-3:2013 in accordance with the Directives
2014/30/EU, 2006/42/EC, 2011/65/EU.
Technical file at:
Berner Trading Holding GmbH
Bernerstrasse 6,
74653 Künzelsau, GERMANY
i.V. Bert Habets
Senior Director Continuous Improvements
18.12.2018
If alterations are performed on the device, this declara-
tion loses its validity and the warranty expires.
Environmental protection, disposal.
Packaging, worn out power tools and accessories should
be sorted for environmental-friendly recycling.