Thrustmaster T300 RS Manual Del Usuario página 10

ADJUSTING THE PEDALS' HEIGHT AND SPACING
Using a Phillips screwdriver (not included), remove the 2 attachment screws holding the pedal heads to
the pedal arms.
Next, adjust the pedal heads' height and spacing to suit your preferred driving style:
- 6 different positions are available for the gas pedal.
- 6 different positions are available for the brake pedal.
Once you are happy with the height and spacing, replace and re-tighten the 2 attachment screws
holding the pedal heads to the pedal arms.
ATTACHING THE RACING WHEEL
Attaching the racing wheel to a table or a desktop
1. Place the racing wheel on a table or any other horizontal, flat and stable surface.
2. Insert the fastening screw (11) in the attachment system (10), then tighten the device by turning the
screw counterclockwise, so that it feeds into the large threaded hole (9) located beneath the racing
wheel, until the wheel is perfectly stable.
WARNING: Never tighten the screw alone, without the attachment system in place!
(This could damage the racing wheel.)
9/20