Ego Power+ BCX3800 Manual Del Operador página 12

TROUBLESHOOTING
EN
PROBLEM
Fail to start.
Stop working.
Excessive vibration or
noise.
The cutting line can't
be released.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
12
56 VOLT LITHIUM-ION REAR MOTOR BIKE-HANDLE BRUSH CUTTER — BCX3800
CAUSE SOLUTION
◾
The battery pack is not attached to the
brush cutter or no electrical contact between
the brush cutter and battery.
◾
The battery pack is depleted.
◾
The lock-off button has not pushed to
position "ON" before pressing the switch
levels.
◾
The battery pack or brush cutter is too hot.
◾
The brush cutter is overload.
◾
The battery pack is disconnected from the
tool.
◾
The battery pack is deleted.
◾
Dry gearbox
◾
The unbalance cutting line.
◾
The 3-teeth blade is bent or damaged
◾
The line in the trimmer head has been run
out.
◾
The cutting line has not been installed
properly.
SOLUTION
◾
Reinsert the battery plug into the
hedge trimmer
◾
Charge the battery pack with the
specified charger.
◾
Before using the trimmer, confirm
the lock button is unlocked.
◾
Allow the battery pack or
hedge trimmer to cool until the
temperature to normal temperature.
◾
The machine will recover when the
load is removed. For continuous
working, reduce the load of the
machine.
◾
Re-install the battery pack.
◾
Charge the battery pack with the
specified charger.
◾
Remove sealing screw and add
lubricating oil.
◾
Lightly tap the bump knob on the
ground while operating the trimmer.
◾
Replace a new blade.
◾
Assemble a new cutting line into the
brush cutter.
◾
Remove the cutting line and re-
assemble the cutting line.