Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English / USA
:
Remove remaining rope from the
rotor and grip.
:
Tie a simple overhand knot in the
new rope (see "Specifications") and
then thread it through the top of the
grip and the rope bushing (6).
42
6
:
Thread the rope through the rotor
and secure it with a simple
overhand knot.
:
Coat rope rotor bearing bore with
non-resinous oil.
:
Slip rotor over starter post – turn it
back and forth to engage anchor
loop of rewind spring.
3
4
:
Refit the pawl (5) in the rotor.
:
Fit the washer (4) on the starter
post.
:
Use a screwdriver or suitable pliers
to install spring clip (3) on starter
post and engage it on the pawl's peg
– the spring clip must point
counterclockwise clockwise as
shown in the illustration.
:
Go to "Tensioning the rewind
spring".
5
FS 110
Publicidad
Capítulos
Tabla de contenido
