Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Input, output and audio controls
1
2
3
4
5
6. COOLER
1. RCA JACK INPUT: Input of the signal to be amplified. Connect to the radio/
player using high quality shielded RCA cables to prevent unwanted noise.
2. LEVEL: Level control for the signal at the amplifier's input.
3. CROSSOVER:
▪ HIGH PASS FILTER (H.P.F.):
This variable control allows you to select the
initial frequency from 10Hz ~ 90Hz that will be reproduced by the amplifier.
▪ LOW PASS FILTER (L.P.F.):
This variable control allows you to select the
final frequency from 90Hz ~ 15KHz that will be reproduced by the amplifier.
4. BASS BOOST:
▪ BASS:
Variable control for bass boost from 0dB ~ +10dB.
▪ FREQ:
Variable control for BASS boost frequency from 30Hz ~ 70Hz.
5. FLAT KEY: This switch allows you to turn the FLAT mode on or off. Settings
made on the CROSSOVER and BOOST controls will be turned off when
using this mode.
6. COOLER: It cools the amplifier. Install in a cool place being careful to not
obstruct the air vents.
3
Publicidad
Tabla de contenido
