General Instructions; Connection And Operation - LD Systems LDMAUI11MIX Manual De Usuario

Ocultar thumbs Ver también para LDMAUI11MIX:
Tabla de contenido

Publicidad

SETUP, CONNECTION AND STARTUP / AUFBAU, ANSCHLUSS UND INBETRIEBNAHME /
INSTALLATION, CONNEXION ET MISE EN SERVICE / MONTAJE, CONEXIÓN Y OPERACIÓN /
BUDOWA, PODŁĄCZENIE I URUCHOMIENIE URZĄDZENIA / INSTALLAZIONE, CONNESSIONE E
MESSA IN FUNZIONE
EN

GENERAL INSTRUCTIONS

Before startup, the subwoofer of the LD Systems MAUI11MIX PA system must be placed upright on its rubber feet, on a flat surface. Never operate
your system on a trolley, as there is a risk that the entire system might be unstable. Accidents and damage may result. The cooling of the power
amplifier is via the vents in the connector panel on the back of the subwoofer. To ensure adequate cooling, during operation a minimum distance of
50 cm must be maintained between the back of the subwoofer and other objects such as walls for example.
Please ensure the correct connection of audio and power connections for the system and all connected devices such as mixers, CD players, etc. Use
only undamaged cables of suitable diameter and always unwind cable reels completely. If necessary, use cable bridges to avoid tripping over loose
cables. Never place the device directly on an edge. Do not place the subwoofer on a table. To avoid unwanted background noise when turning on
connected devices, always turn on the system last and turn it off first.
SETUP
The LD Systems MAUI11MIX PA system consists of two components:
A. a subwoofer with integrated electronics for both system components.
B. an array column with eight 3" speakers, a tweeter and multi-pole connections in the column foot.
After the subwoofer is placed in the desired position, the array column is attached to the subwoofer. Two sturdy steel pins provide for optimal align-
ment of the multi-pin connectors on the two components.

CONNECTION AND OPERATION

The device allows both the volume of the entire system and the volume of the subwoofer in relation to the total volume to be adjusted separately.
Source devices can be connected using both balanced and unbalanced cables (XLR / 6.3 mm jack / RCA). The integrated 3-channel mixer offers a
microphone input, a high-impedance instrument input for an electric guitar for example, and inputs for source devices with line level.
10
B
A

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ldmaui11mixw

Tabla de contenido