Troubleshooting; Troubleshooting The Tractor - Snapper RPX200 Manual Del Operario

Troubleshooting

Troubleshooting the Tractor

PROBLEM
Engine will not turnover
or start.
Engine starts hard or
runs poorly.
Engine knocks.
Excessive oil
consumption.
Engine exhaust is
black.
Engine runs, but tractor
will not drive.
Tractor steers hard or
handles poorly.
NOTE: For all other problems, contact an Authorized Service Dealer.
24
All manuals and user guides at all-guides.com
LOOK FOR
Brake pedal not
depressed.
Out of fuel.
Battery terminals require
cleaning.
Battery discharged or
dead.
Wiring loose or broken.
Fuel mixture too rich.
Low oil level.
Using wrong grade oil.
Using wrong grade oil.
Too much oil in
crankcase.
Dirty air filter.
Ground speed control
pedals not depressed.
Transmission release
lever in PUSH position.
Parking brake is engaged. Disengage parking brake.
Improper tire inflation.
Fully depress brake pedal.
If engine is hot, allow it to cool, then refill the fuel tank.
See Cleaning the Battery and Cables section.
Recharge or replace battery.
Visually check wiring. If wires are frayed or broken, see authorized
dealer.
Clean air filter.
Check/add oil as required.
See Oil Recommendations Chart.
See Oil Recommendations Chart.
Drain excess oil.
See Servicing the Air Filter section.
Depress pedals.
Move into DRIVE position.
See Check Tire Pressure section.
REMEDY