Foremost MARINA Manual Del Usuario página 7

INSTALLATION PROCEDURE / STEP 6
Install the wall channel. Fasten the wall channel according to the holes from above steps by ST3.5x35
6
flat head screws.
Install the wall bracket. The wall bracket has two parts, take out inner part of the bracket base as the
pics shown. Bracket base will slip down on the single mounting screw. Once you have the height
determined (gap at bottom of door has to be big enough to slide easily through bottom guide) take it
all apart and mix up the epoxy putty and push some in the slotted hole above the screw head on both
bracket base.
LEFT HAND ASSEMBLY
INSTALLATION PROCEDURE / STEP 7
Measure and cut the bottom track. Measure from wall to wall channel at the bottom. Mark the bottom
7
track at the determined distance, and cut from end. Smooth the rough edges (avoid damaging
finished surfaces). Install bottom track.
LEFT HAND ASSEMBLY
The bracket base mounting hole can slip.
Epoxy or shim might be necessary.
- 6 -
RIGHT HAND ASSEMBLY
RIGHT HAND ASSEMBLY