AVS Aeroskin LightShield Pro Instrucciones De Instalación página 6

Installation Steps
Press firmly along all edges of LightShield to ensure adhesion
of tape to hood surface.
20
Begin by routing all 4 wires along drivers side hood. 3-4 Wire Stays are used to hold the electrical wires in position. Clean
mounting locations with an alcohol pad, then remove adhesive backing from Wire Stays. Adhere Wire Stays to hood and
Identify the black, brown and yellow wires. Determine location to route these three wires along the driver side fender area
Locate the single green wire. Route along firewall and along the passenger side fender area and up to the passenger side
green wire
22
NOTE: Actual application may vary slightly from illustrations.
route electrical wires through them.
so that it will be secure and does not interfere with any existing equipment.
light assembly, so that it will be secure and does not interfere with any existing equipment.
21
Page 6 of 7
Raise hood.
electrical wire
Example of Wire Stays
placement locations
electrical wire
black wire
brown wire
yellow wire