Cleaning And Maintenance - Asist AE7V160-25FS Instrucciones De Uso

Protective equipment
Special instructions for protective equipment.
(1) When the container is fi lled with water, the protec-
tive device starts.
Suction stops at this point. The engine is running at
high speed.
Under these circumstances, switch off the vacuum
cleaner and pour out the water. Then assemble and
turn on the machine, it will start working
normally.
(2) When the machine overturns, the machine starts.
Switch off the vacuum cleaner and turn it to the cor-
rect position, then
turn on the machine.
(3) If the protective device is activated, the engine will
be damaged and may cause a fi re. Vacuum cleaner
immediately
turn off , eliminate the cause, then you can use it
again.

CLEANING AND MAINTENANCE

! Before cleaning and maintenance, always unplug
the appliance.
Check the machine regularly for damage.
Store the device in a dry place and out of reach of
children.
Never clean any part of the device with a hard, sharp
or rough object.
Storage when not used for a long time
Do not store the device in a place where the tempera-
ture is high. If possible, store the device in a place
with a constant temperature and humidity.
Possible defects
In case of any problems, switch off the device and al-
ways unplug the power cord from the electrical outlet.
The following problems may occur during operation:
Defects Causes
1. The power cord
is not securely
The engine plugged in or is
does not damaged
run 2. Malfunctioning
switch
Solution
1. Connect the cable
or replace it
2. Replace the
switch
42
1. Clogged hose
or nozzle
Poor 2. The dust fi lter
suction is dirty
power 3. The dust
container is not
attached properly.
SPECIFICATIONS
Input voltage 230 V
Input frequency 50 Hz
Power consumption 1600W
Vacuum cleaner container volume 25L
Vacuum min. 20kPa
Weight 7.2 kg
Blowing function
Subject to change.
Caution: The vibration level may vary during power
tool operation from the declared value depending on
the way the power tool is used and depending on the
following conditions: Method of power tool use and
type of material being cut or drilled, conditions of the
power tool and method of its maintenance, appro-
priateness of the used accessories and ensuring its
sharpness and good conditions, the strength of handle
gripping, use of anti-vibration equipment, suitability of
the power tool for the purpose for which it has been
designed and compliance with workfl ows according to
manufacturer's instructions.
If this power tool is used in an inappropriate manner, a
hand/shoulder vibration syndrome may appear.
Caution: For clarifi cation, it is necessary to consider
the level of vibrations in specifi c conditions of use in all
operating modes, e.g. the time when the power tool is
switched off except for the operation time, and when
it idles, i.e. performs no work. This may substantially
decrease the exposition level during the whole operat-
ing cycle.
Minimize the risk of vibrations, use sharp chisels, drill
and blades.
Keepthe power toolin compliancewith theseinstruc-
tions and provide for its proper lubrication.
When using the power tool regularly, invest into anti-
vibration equipment.
Do not use the power tool under temperatures lower
than 10°C. Plan your project containing work with the
power tool producing high vibrations carefully and
spread it over more days.
Subject to changes.
ENVIRONMENTAL PROTECTIONWASTE MA-
NAGEMENT
1. Loosen the hose
or nozzle
2. The dust fi lter
must be cleaned
3. Secure the dust
container correctly.