Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
10
1.
Place the DRAWER FRONT PANEL ( G ), DRAWER LEFT PANEL ( H ), DRAWER RIGHT
PANEL ( I ) and DRAWER BACK PANEL ( J ) face down on a smooth soft surface. The
side with the holes should be facing up.
2.
Insert the CAM BOLT ( 1 ) into the corresponding hole of DRAWER FRONT PANEL ( G )
as shown in below figures.
3.
Use a hand screwdriver to tighten the CAM BOLT ( 1 ) clockwise.
**
Repeat all 1-3 steps for all 4 drawers.
CAM BOLT
1
×20
Please call for replacement parts or assistance: 1-888-568-3818
Young Chain Company Limited
Page 15
Publicidad
Tabla de contenido
