Dyna-Glo SIGNATURE Serie Manual De Instrucciones página 25

OPERATING INSTRUCTIONS
• Do not use sharp or pointed tools to clean appliance.
• Do not use abrasive oven cleaners, steel wool or metal brushes to clean porcelain
grates or appliance body. They will damage the finish.
• Replace damaged part(s) only with Dyna-Glo certified replacement parts. Do not
attempt to repair damaged parts.
• The appliance becomes HOT during use. Use heat resistant gloves while accessing
the inside of the appliance.
Shutting Off Your Appliance
1. When cooking is complete, you may choose to burn off any residual grease or food residue.
Simply turn the temperature control dial to 450F and run the unit for at least 10 minutes for
normal use or 20 minutes for foods that resulted in high amounts of grease. Burning the residue
after cooking will minimize the risk of a grease fire the next time the grill is used. Be sure to set
a timer for the desired burn-off, so you can resume the rest of the shut-down process.
WARNING: DO NOT leave the flywheel open, when performing a burn-off.
2. Turn the dial to "Shut Down Cycle", but DO NOT press the power button. The control panel will
display "OFF", but the fan will continue to blow air into the fire pot to extinguish the pellets. Allow
the unit to run, until the shut-down cycle is complete. Unplug the unit, once the shut-down cycle
is complete.
WARNING! DO NOT PRESS THE POWER BUTTON OR UNPLUG THE APPLIANCE WHILE THE
FAN IS STILL WORKING ON THE SHUT DOWN CYCLE. THE GRILL WILL AUTOMATICALLY
SHUT OFF WHEN THE CYCLE IS COMPLETE. INTERRUPTION OF THE SHUT DOWN CYCLE
COULD RESULT IN A FIRE IN THE HOPPER CHAMBER.
Wait until the unit has completely cooled before placing a cover or moving the unit to storage.
Clearing The Hopper
Removing the pellets from the hopper may be necessary, if
inclement weather or high humidity is expected. To empty the
hopper simply locate the rear hatch on the back of the hopper.
Before opening the hatch, hold a container near the opening to
prevent pellets from falling to the ground. Slowly open the hatch
and allow the pellets to exit the hopper. Ensure that the hatch
is completely closed, after clearing the hopper.
Ash Removal
Ash will accumulate in the fire pot during and after each use.
Always inspect the fire pot before use. Always wait until the
ashes are completely cooled before removing. Ashes should be placed in a metal container with a
tight fitting lid. The closed container of ashes should be placed on a noncombustible floor or on the
ground, well away from all combustible materials, pending final disposal. If the ashes are disposed
of by burial in soil or otherwise locally dispersed, they should be retained in the closed container until
all cinders have thoroughly cooled.
CAUTION
25