Using The Appliance; Temperature Selection - Eldom solo DA200 Manual De Instrucciones

OVERVIEW
1. Spray nozzle
2. Water inlet
3. Steam intensity regulator
4. Steam burst button
5. Spray button
6. Handle
7. Indicator lamp – temperature
8. Base + charging port
9. Water tank
10. Thermostat knob
11. Soleplate
12. Charging base
13. Charging connector
14. Power cord
15. Lock
16. Indicator lamp – connection
SPECIFICATION
Power: 2800 W
Power supply: 220-240V ~ 50-60Hz
USE
Before the first switching on of the iron, fully unroll the power cord (14). During the initial use of the iron,
harmless odour may be emitted. This is short-lasting and has no effect on the operation.
Match the ironing temperature to the type of the fabric. If the type of the fabric is not known, start ironing with
the lowest temperature and increase it gradually to achieve positive results.

USING THE APPLIANCE

Regardless of the selected ironing option, place the base (12) on a stable surface.
Wireless ironing
- place the iron on the base (12),
- move the lock button to the
- after heating, the iron can be removed from the base and you can start ironing,
- often put the iron on the base to charge it during ironing.
Ironing with the power cord
- place the iron on the base (12) so that the
- move the lock button to the
- adjust the iron position by turning it to the left or right until you hear a click,
- the iron will be connected to the charging base and locked,
- after connecting the base, the iron will allow for ironing in wired mode like a regular iron.

TEMPERATURE SELECTION

Always refer to the garment manufacturer's recommendations for the correct temperature setting.
Before ironing, always look at the label on your clothing and follow the recommendations on it.
If there are no care instructions on the garment, you can follow the instructions in the table below.
OPERATING INSTRUCTION
4
3
2
1
11
symbol,
sign on the handle coincides with the power cord (14),
symbol,
STEAM IRON DA200
5 6
12
10 9
16 15
EN
7
8
13 14
11