Eldom solo DA200 Manual De Instrucciones página 12

Plancha de vapor inalámbrico
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24
If the type of the fabric is unknown, start with the lowest temperature and increase it gradually until a satisfactory
result is reached.
If the garment is composed of different materials, select the lowest recommended temperature.
Material
acetate, nylon
silk, wool, polyester
cotton, linen
AUTO-OFF FUNCTION
The iron left unmoving will turn off automatically after about 30 seconds when horizontal and after about 8
minutes when
vertical. Turning off is signalled with the pulsating indicating light (7) and several seconds of audible signal.
Shake the iron to turn it on again.
IRONING WITHOUT STEAM
Before plugging in the iron to the mains, place it on the base (12), set the thermostat knob (10) in the "OFF"
position, and the steam regulator (3) in the "0" position (no steam).
Plug in the iron to the mains: the light (7+16) will go on.
Set the temperature with the thermostat knob (10). The light (5) will go on.
Ironing can be started when the light (7) changes color - it means that the iron has reached the required
temperature
The thermostat will maintain the selected temperature, which will be signaled by a color change (7).
IRONING WITH STEAM
Ironing with steam and the steam shot function is only possible when high temperature is set. The highest
temperature is marked "MAX" on the thermostat knob (10).
Intensity of steam is et with the regulator (3).
The button (4) may be used to release additional volume of steam. The additional steam shot facilitates ironing
of exceptionally resistant creases.
NOTE. Steam is hot. Danger of scalding or burns. The sole of the iron is heating up very quickly and needs
more time to cool down. It must not be touched
FILLING THE WATER TANK
Before filling or refilling the tank with water, make sure that the plug is removed from the socket and that the
steam intensity regulator (3) is set to the "0" position.
Pour clean tap water at room temperature into the iron.
For filling the iron tank use the supplied container adapted in shape to the inlet opening.
Do not pour water into the iron directly from the tap!
When pouring water into the iron, remember that the water level should not exceed the "MAX" mark on the
tank (9).
ANTI-CALC SYSTEM
A special filter inside the water tank softens the water and prevents limescale from settling on the soleplate. The
filter is durable and does not require replacement.
Caution: Use only tap water. Distilled and demineralised water makes the anti-calc system ineffective,
changing its physicochemical properties.
SPRAYER
After water is poured into the tank (9), it may be used to sprinkle the ironed spot with the button (5).
12
Thermostat position
·
··
···

Publicidad

Tabla de contenido
loading

Tabla de contenido