i.safe MOBILE IS330.2 Guia De Inicio Rapido página 6

PREPARATION
The device has two slots for one SIM card each and one slot for a
microSD card up to a size of 128 GB. The slots are located in the bat-
tery compartment and are marked "SIM 1", "SIM 2" and "microSD".
Insert the SIM card into the slot.
Insert the microSD card into the slot provided.
Place the battery in the battery compartment.
Hand-tighten the screws using the Torx Screwdriver provided.
Check that the battery is seated correctly and securely.
SWITCHING ON
Press and hold the on/off key for about 3 seconds.
When turning on the device for the first time, follow the instructions on the screen.
Enter the device or SIM PIN when the input dialog for the device or SIM PIN appears after
switching on.
If you have inserted two SIM cards, select a favorite card. Information on operating the
device can be found at www.isafe-mobile.com/en/support/service under the menu item
"FAQ".
CHARGING
Only charge the device outside of explosion hazardous areas.
Only charge the device using the USB-C Cable supplied.
Do not charge the device in the vicinity of flammable substances.
Only charge the device at ambient temperatures between +5 °C to +35 °C (+41 °F to +95 °F).
Charge the device under dry indoor conditions only.
Do not charge the device in environments dusty or humid.
Connect the adapter suitable for your country to the power supply unit.
Connect the USB-C Cable to the power supply unit.
Connect the USB-C Cable to the USB interface of the device.
CONNECTING APPROVED ACCESSORIES
Only connect accessories approved by i.safe MOBILE to the device. Accessories approved by
i.safe MOBILE can be found at www.isafe-mobile.com/en/products
Connect approved accessories to the ISM interface of the device only outside of explosion
hazardous areas.
Operate approved accessories in explosion hazardous areas only on the ISM interface of the
device. Wired connections via the USB interface are prohibited.
Connect the plug of the accessory securely to the ISM interface of the device and check that
the plug is seated correctly and securely before entering explosion hazardous areas.
Close the ISM interface with the cover provided when you are not using accessories.
Only use USB interface outside of explosion hazardous areas.
You should never open the cover of the USB interface in explosion hazardous areas.
6