Bergstrom DUAL POWER II Instrucciones De Montaje página 20

DUAL POWER II
EN
EVAPORATOR
3- Mark the evaporator support points.
4- Bore Ø7 holes for throughbore or Ø9 to
position M6 rivet nuts.
5- Secure the evaporator with (4) 6/100x15
screws with grower and flat washers if M6
rivet nuts are fitted, or (4) 6/100x25 screws
in the case of throughbores. In the case of
throughbores, fasten with flat and rubber
washers on the outside and flat washers
and M6 nuts on the inside (this is done to
prevent water from entering the cabin).
See diagram (*).
*
Cabin area exterior
6/100x25 Screw
Ø6 Flat washer
Rubber washer
Roof or side
Ø6 Flat washer
M6 Self-locking nut
Cabin area interior
5
5
5
20