Peg-Perego PRIMO VIAGGIO SLK Instrucciones De Uso página 23

4 The car seat handlebar has four fixed positions. To
rotate it, press the two buttons on the handlebar and
move this to the required angle. Ensure it clicks into
position.
• Position A: the in-vehicle position;
• Position B: the position for transport by hand and for
installation on a base, stroller or chassis;
• Position C: this is the resting position;
• Position D: stops the car seat from rocking.
Instructions for use without base
IMPORTANT! The car seat must be parallel to the
5
ground. If necessary, use rolled-up towels or swimming
pool float tubes under the car seat, in the folds of the
vehicle's seats.
Fit the car seat with the child seated inside,
remembering to secure the child with the harness. Fully
lower the handlebar of the car seat (point 4 -position A).
6 Slide the lower part of the vehicle seatbelt into the two
guides on the car seat handlebar (fig_a) and buckle it
(fig_b), ensuring the seatbelt is taut, as shown in the
figure.
Grasp the upper part of the vehicle seatbelt and pass it
behind the car seat backrest (fig_c).
7 Insert the belt into the rear guide (fig_a). Tighten the
vehicle seat belt (fig_b). Installation is now complete.
8 To release the harness, press the red button on the
crotch strap buckle (fig. a) and remove the straps. To
engage the harness, place the two shoulder strap
tongues in position and insert them into the buckle of
the crotch strap until they click into place (fig. b).
9 To slacken the harness, insert a finger through the seat
opening (1), keep the metal button pressed, and with
the other hand pull on the straps (2).
10 To tighten the straps until they are snug to the child's
body, pull the central adjustment strap towards you.
CAUTION: Do not over-tighten the straps, and
ensure you leave minimum slack.
IMPORTANT! In winter, do not strap the child into
11
the car seat wearing bulky, heavy clothing, and do
not place blankets between the child's body and the
harness. This could cause incorrect positioning of the
safety harness, with serious consequences in the event
of a collision.
Use a blanket or an approved Peg Perego accessory to
protect your child from the weather.
12 The harness and the "Side Impact Protection" headrest
can be adjusted simultaneously to 6 different heights so
as to follow the growth of the child.
To adjust the height, press the rear height adjustment
button (on the car seat backrest) and at the same time
raise or lower the straps and headrest to the required
position, ensuring that they click into place. Slacken
the shoulder straps before adjusting the height of the
harness and headrest.
13 The headrest may be set in 6 different positions.
14 The safety harness is at the right height when the slots
in the backrest are at shoulder height or just below
(green area), as shown in the figure.
23