Joie i-Gemm 3 Manual De Instrucciones página 11

The completely assembled base is shown as
!
The ISOFIX connectors must be attached and locked onto the
-1
ISOFIX anchor points.
6
!
The load leg must be installed correctly with green indicator.
6. Push the infant carrier module down into the base
enhanced infant child restraint is secure, the enhanced infant child
restraint indicator shows green.
!
Pull up on the infant carrier module to be sure it is securely latched
into the base.
7. To release the infant carrier, pull the infant carrier up
squeezing the infant carrier release button.
8. To remove the base, press the secondary lock button
-2
then the button on the ISOFIX connectors before removing the
10
base from the vehicle seat.
9. Press the ISOFIX releasing button to fold the ISOFIX.
Vehicle Belts Installation see images
1. Unfold the load leg from storage compartment.
2. After placing the base on the vehicle seat, extend the load leg to
floor , When the load leg indicator shows green means it is
5
installed correctly, red means it is installed incorrectly.
!
The load leg has 24 positions. When the load leg indicator shows
red this means the load leg is in the wrong position.
!
Make sure the load leg is in full contact with the vehicle floor pan.
!
Squeeze the load leg releasing button, then shorten the load leg
upwards.
3. Open the lock-off and route the vehicle safety belt through the belt
-1
path , and lock it into the buckle.
12
4. Tighten the vehicle safety belt as much as possible while pushing
9
6
, if the
7
8
-2
9
-1
9
-1
10
10
11
-
12 16
1
5
-2
12
down on the base, and check it is not loose or twisted, then close
the lock-off.
!
The infant child restraint can not be used if the vehicle safety belt
with female buckle is too long to tie the base.
-2
6
!
Check that the safety belt does not move by pulling and pushing
hard on base. If belt loosens or lengthens, repeat procedure.
5. The installed base is shown as
!
Please ensure that there is no gap between the seat and the bottom
of the base.
!
while The safety belt must go under the lock-off, not over the lock-off.
-1
!
The safety belt must be locked into the buckle.
first and
!
The load leg must be installed correctly with green indicator.
6. Push the infant carrier module down into the base.
7. If the enhanced child restraint is secure, the enhanced child restraint
indicator shows green.
!
Pull up on the infant carrier module to be sure it is securely latched
into the base.
8. To release the infant carrier module, pull the infant carrier up
while squeezing the infant carrier release button.
-3
-3
12
.
13
15
-4
12
13
-2
13
-3
13
14
-2
16
-1
16
10