3TECH USC-6L Manual De Instrucciones página 21

ENHANCED CLEANING
4. Turn on the main switch. Press TEMP button to set the water temperature to 45ºC
(113ºF). Press TC to turn on the heater,
actual water temperature. When the water reaches the set temperature,
indicating the heater is turned o .
Warm water and dishwashing liquid can soften grease and improve cleaning e ciency.
5. Press TIME button to set the timer to 10 minutes. Press On/O button to start
cleaning. Grease will dissipate and appear to be like black smoke in the water.
6. When it stops, open the drainage valve to release the dirty water. Close the valve
afterwards.
7. Clean the tank and add fresh water. Wash the items for another 3 minutes to remove
the residual debris and the detergent.
SPECIAL CLEANING
3. Turn on the main switch. Press TEMP button to set the water temperature to 50ºC
(122ºF). Press TC to turn on the heater,
actual water temperature.
When the water temperature reaches the set temperature,
heater is turned o .
The heater has dual protection. It will be turned o automatically after 50 minutes.
4. Press TIME button to set the timer to 15 minutes.
5. Press Function button to select the degas function.
to start degassing. After 2 minutes it changes over to normal cleaning automatically.
6. When it is done, remove the basket and the items. If there are large quantities of items
and residual debris, reset the timer for 5 minutes and repeat the cleaning.
20
Debris accumulated over a long period of time,
greasy or heavily soiled.
Suitable Locations: metal decoration and jewelry makers,
hardware manufacturers, shooting clubs, homes, golf clubs,
automotive repair shops.
Cleaning Method:
1. Large items can be put in the tank directly. Small items
can be put in the basket then put in the tank. Do not put
the items on top of each other to avoid rubbing during
cleaning.
2. Add water to a level between MIN and MAX and above
the area to be cleaned.
3. Add 50 ml (3 tablespoons) of dishwashing liquid.
fl ashes. Close the lid. LED Actual displays
Silver, copper or brass items with oxidation which has
darkened the items will need special cleaning.
Suitable Locations: silver, copper or brass product
manufacturers, home, shooting clubs.
Cleaning Method:
1. Put the items in the basket and then in the tank, add
water to a level between MIN and MAX and above the
area to be cleaned.
2. Add special solution that can remove silver or copper
oxidation according to the ratio recomm- ended
(typically 1:10), Use special solutions according to the
instructions for brass cartridges.
fl ashes. Close the lid. LED Actual displays
dims,
dims, indicating the
button illuminates. Press On/O