Preparing The Remote Control; Replacing The Remote Control Battery; Indicator Lights / Displays - Silvercrest SSP 360 A1 Instrucciones De Utilización Y De Seguridad

operation. The operating time may vary based on use
(speed).

Preparing the remote control

On delivery the remote control
installed. An insulating strip prevents early battery discharge.
Pull the insulating strip out of the battery compartment.
Replacing the remote
control battery
Open the battery compartment as shown in Fig. A.
Insert the included battery (CR2025). Please note the
polarity. The positive terminal (+) must face up.
Slide the battery compartment back into the remote
control

Indicator lights / displays

The LED indicator
and extinguish once the rechargeable battery is fully
charged.
54 GB/IE
.
10
will light up red whilst charging
7
already has a battery
10