Important Information About Propane; Specification - Agio 2127022 Manual Del Usuario

IMPORTANT SAFETY INFORMATION ABOUT
A LP-gas cylinder for use with this appliance must have a capacity of
must be equipped with a Type 1 connector and an OPD (overfill protection device).
Figure 1
The LP-gas supply cylinder to be used must be constructed and marked in accordance
with the specification for LP-gas cylinders of the U.S. Department of Transportation
(DOT) or the National Standard of Canada, CAN/CSA-B339, Cylinder, Sphere and Tubes
for the Transportation of Dangerous Goods.
The cylinder supply system must be arranged for vapor withdrawal.

 The cylinder used must include a collar to protect the cylinder valve.
 This appliance shall be used only outdoors in a well-ventilated space and shall
not be used in a building, garage, or any other enclosed space.
 When this appliance is not in use, the gas must be turned off at the supply
cylinder.
 Storage of this appliance indoors is permissible only if the cylinder is
disconnected and removed from the appliance.
 Cylinders must be stored outdoors in a well-ventilated area out of the reach of
children. Disconnected cylinders must have threaded valve plugs tightly installed and
must not be stored in a building, garage or any other enclosed areas.
The gas hose is routed through a "U" bolt to prevent the hose from coming in contact with
the burner. DO NOT remove the hose from the "U" bolt. See Figure 2.
The maximum inlet supply pressure,as follows:
"Max.gas supply:6922 in wc (1723Kpa)"
INPUT
Clearances to
combustible surfaces
Propane Regulator
Pressure
Natural Gas Minimum
Inlet Pressure
PROPANE (LP) GAS
Figure 1
SPECIFICATIONS
Sides 60.96 cm / 24 inches
Regulator hose
pointed down
60,000 Btu/hr(17.6kW)
2.74 kpa / 11 in water column
1.74 kpa / 7 in water column
4
9 kgs / 20 lbs
Figure 2
Top:182.8cm/72 inches
. and