NuWave Brio 6Q Manual Del Propietário página 9

INSTRUCTIONS
3. To un-pause and go back to cooking, slide the Fry Pan
Basket with Base Tray back into the Brio.
4. Once the unit finishes cooking, the LED display will show
End with three (3) beep sounds.
5. The START/PAUSE button is also used to mute and
unmute the beep sounds. To mute the beep sounds,
press and hold the START/PAUSE button for two
seconds. The Brio will remain mute until it is unmuted by
again pressing and holding the START/PAUSE button
for two seconds or turning off the Brio.
DELAY
1. Adjust the cooking temperature and time after turning on
the Brio with the ON/OFF button, then press the DELAY
button to add a delay before cooking.
2. When the DELAY button is pressed, the LED display will
show 01:00 (default delay time), delay, and time.
3. Use the [↑] and [↓] buttons above and below the time
icon to adjust the delay time up or down. Delay time can
be adjusted up to 24-hours (24:00).
4. During the delay cycle, the ":" will flash indicating the
delay time has started counting down.
5. The delay time can be increased or decreased using
the [↑] and [↓] buttons above and below the time icon
anytime during the delay cycle.
6. To stop the delay cycle at any time, simply press the
DELAY button. The unit will end the delay cycle and
move directly into the next cooking function.
7. After the delay time has elapsed, the unit will
automatically move into the next cooking function.
8. Once the unit finishes cooking, the LED display will show
End with three (3) beep sounds.
TEMP
1. To set a different cooking temperature, press the [↑] and
[↓] buttons above and below the temperature icon. The
control panel will display 360F and temp.
• The temperature will adjust in 5-degree increments
between 60°F and 400°F.
2. To quickly adjust the temperature, hold down the arrows
until desired cooking temperature is reached.
16 16
instructions
Note: Cooking temperature can be adjusted at any time
before or during the cooking process. Once the display
is switched to temperature display, it will remain in the
temperature display.
TIME
1. To set a different cooking time, press the [↑] and [↓]
buttons above and below the time icon. The control
panel will display 00:15 and time.
• The time will adjust in 1-minute increments.
2. To quickly adjust the time, hold down the arrows until
desired cooking time is reached.
• The maximum selectable cooking time differs
depending on the selected cooking temperature.
• 60°F - 200°F, maximum cooking time is 99 days, 99
hours (99.99).
• 205°F - 275°F, maximum cooking time is 99 hours, 99
minutes (99:99).
• 280°F - 345°F, maximum cooking time is 10 hours
(10:00).
• 350°F - 400°F, maximum cooking time is 1 hour
(01:00).
Note: Cooking time can be adjusted at any time before or
during the cooking process.
PREHEAT
The unit will preheat to the temperature of the next
cooking cycle. For example, if Sear 1 is set to 400F, the
unit will preheat to 400F. If Sear 1 is not used, the unit
will preheat to the set cooking temperature.
1. Press the ON/OFF button and adjust your cooking
temperature and time for stage 1 cooking.
2. Press the PREHEAT button to engage the preheat function.
• The LED display will show set cooking temperature,
pre, and temp.
• The unit will ALWAYS preheat to the cooking
temperature of the next cooking cycle.
3. Press the START/PAUSE button to begin preheating.
17 17
nuwavenow.com nuwavenow.com