Emergency Opening; Low Battery Indicator - Arregui STYLO 19010 Manual De Instrucciones Y Garantías

<EN>
• Programming master code.
- Press "0" twice. Then press the reset button. The yellow light will be on.
- Input any 3-8 digits you want, press "#" to confirm. 2 beeps will
indicate the personal code has been accepted and stored.
B.3. NORMAL OPENING
To open the safe, enter the key and your personal code followed by the
letter "#". A green light will be on. Turn the key clockwise to open the door.
If the entered code is incorrect, 3 short deep sounding beeps will sound. If
the incorrect code is used 3 times consecutively, you must wait for 20 se-
conds before reattempting. If again the incorrect combination is selected 3
times, you must wait approximately 5 minutes before reattempting access.
B.4. CLOSING
To close the safe, push the door and turn the key counterclockwise.
C. EMERGENCY OPENING
If you forget the code for opening, the safe can be opened using the
emergency key.
• Remove the small plastic cover on the front panel by pressing the left
side of the cover inward.
• Insert the emergency key into the key hole and turn it counter-clockwise
direction. Insert the user key and turn it to open the safe.
• Once the safe is open, press the reset button on the back of the door.
• Change the code for opening (see point B.2)
CAUTION:
• Do not keep the keys in the safe itself.
D. LOW BATTERY INDICATOR
Each time that you use the safe, the electronic system verifies the condi-
tion of the batteries.
If the batteries are low, the red light (in the middle of the number panel)
will warn you immediately. The safe needs 4 x 1.5 V alkaline batteries that
are placed at the back of the door. Open the cover of the battery holder and
place the batteries taking into consideration their polarity. Once you have
changed them, you must reprogram the opening codes, (see point B.2).
E. INSTALLING THE SAFE
To reduce the risk of theft of the safe, it can be secured to floor, wall or in
a cupboard. For your convenience, there are holes (diameter 8mm) on the
back and in the bottom; therefore it can be fixed by the expansion bolts.
CAUTION: The safe should be placed horizontally when installing the safe.