Lionelo Bastiaan One Manual De Usuario página 13

SAFETY SEAT BELTS
To fasten belts in the safety seat (fig. 4):
1.
Connect belt clasps together.
2.
Make sure the connection is proper
3.
Insert them into the fastening, you will hear a distinctive click.
4.
Make sure the belts have been properly tightened and are not
twisted. To undo the belts, press the red button.
5.
After undoing the seat belts, you can put them in special hooks
located on the side of the seat.
To disassemble 5-point belts of the safety seat (fig. 5):
1.
Press the red button and loosen the belts.
2.
Remove the loose belts from the connectors in the back of the
safety seat.
3.
Take the belts from the safety seat through holes.
4.
Remove arm pads.
5.
Roll up shoulder belts and place them in the safety seat holes (fig. 6).
6.
Loosen the crotch belt, take the buckle located under the safety
seat and remove the belt. Pull the crotch belt and pull through the
hole (fig. 7, 8).
To assemble the belts again, retake the actions above in reversed order.
Make sure the belts have been properly inserted in the buckles and are
not twisted (fig. 9).
Safety seat belts tension adjustment
1.
Make sure the safety seat belts fit tight to the child's body and are
not twisted.
2.
To tighten the belts, pull the shoulder belts upwards and pull the
tension adjustment belt at the same time (fig. 10).
3.
To loosen the belts and adjust their length, press the button between
the child's legs and pull the shoulder arms. Make sure you pull the
belts, not shoulder pads (fig. 11).
‑ 13 ‑ EN