Description Of The Components - Chicco Kiros-Evo Manual De Instrucciones

Kiros Evo
i-Size Base
INSTRUCTIONS FOR USE
IMPORTANT!
READ CAREFULLY AND KEEP FOR FUTURE
REFERENCE.
VERY IMPORTANT! TO BE READ IMMEDI-
ATELY.
IMPORTANT: READ CAREFULLY THE ENTIRE IN-
STRUCTIONS BOOKLET BEFORE USE IN ORDER
TO AVOID RISKS WHEN USING THE PRODUCT
AND STORE IT FOR FUTURE REFERENCE. FOLLOW
THESE INSTRUCTIONS CAREFULLY IN ORDER NOT
TO COMPROMISE YOUR CHILD'S SAFETY.
WARNING: BEFORE USE, REMOVE AND DIS-
POSE OF ALL PLASTIC BAGS AND PACKAGING
MATERIALS AND KEEP THEM OUT OF REACH
OF CHILDREN. IT IS RECOMMENDED TO DIS-
POSE OF THESE ITEMS AT A SEPARATE WASTE
SORTING COLLECTION POINT, AS REQUIRED
BY REGULATIONS IN FORCE.
DO NOT use the product for more than 5 years.
After this period, alterations of the materials
(e.g., due to exposure to sunlight) may reduce
or compromise the product's effectiveness.
1.1 PRODUCT CONFIGURATIONS
The i-Size Base is approved for use with the
following child car seats:
- Kiros Evo i-Size Clip-On and Kiros i-Size Clip
On (Fig. A) compatible with the Alysia stroller.
- Kiros Evo i-Size Fast-In and Kiros i-Size Fast-In
(Fig. B) compatible with the Best Friend stroller
and with other strollers in the Chicco range.
These instructions refer to the installation of
the i-Size Base in the car; to install compatible
seats, refer to the manual of each child car seat.
• This is a base for a Chicco i-Size car seat,
approved according to UN/ECE Regulation
R129, for use in vehicles with "i-Size compat-
ible" seats as indicated by the car manufac-
turer in the car instruction manual and the
vehicle compatibility list.
In case of doubt, please contact the child car
seat manufacturer or dealer.
The vehicle compatibility list can be
found in the product sheet online or by
scanning the QR code on the last page of
this manual.
• WARNING! Serious Danger! Do not install
the child car seat on seats where the airbag
is activated.

1.2 DESCRIPTION OF THE COMPONENTS

i-Size base
Fig. C
A. Isofix connectors
B. Isofix connector removal lever
C. Isofix system connection indicators
D. Isofix connector release buttons
E. Child car seat fastening slots
F. Child car seat correct fastening indicator
G. Support leg
H. Support leg height adjustment button
I. Leg support correct installation indicator
J. Rebound bar
1.3 INSTALLATION AND REMOVAL OF THE
I-SIZE BASE
Proceed as indicated to install the i-Size base:
- Remove the plastic cover from the Support
Leg (Fig. 1).
- Extract the Support Leg (G) (Fig. 1A). An
acoustic signal will activate and stop when
the i-Size base has been installed correctly.
- Completely extract both Isofix connectors
(A) of the base by pulling the connector ex-
traction lever (B) (Fig. 2). Make sure that the
system is extracted to the end stop.
- Position the i-Size base on desired seat and
fasten the Isofix connectors to the anchor-
age points found between the backrest and
the vehicle seat (Fig. 3). You will hear a "click"
when the connectors fit into place.
WARNING! Make sure that the connection
was made correctly by checking that the two
indicators (C) are green.
- Push the i-Size base firmly against the back-
10