Problem
The engine does not start.
The engine does not oper-
ate smoothly or cannot op-
erate at full speed.
Transportation and storage
WARNING
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
The wheels let you move the product manually for
shorter distances. For longer distances, lift the product
to move it or put the product on a vehicle.
CAUTION
behind a vehicle.
•
Move the fuel lever to the left to close the fuel valve.
30
Solution
Do a check if there is fuel in the tank and it is the correct fuel. Make sure there is no
water in the fuel.
Make sure that the fuel valve is in the "ON" position.
Make sure that the ignition key is in the "START" position.
Make sure that the spark plug cable is connected to the spark plug.
The engine is flooded. Adjust the choke, refer to the operator's manual for the engine.
Make sure that the choke is in the "ON" position for cold starts. Adjust the choke, refer
to the operator's manual for the engine.
Do a check of the oil level. The engine has an oil alert system that stops the engine if
the oil level is too low.
Make sure that the air filter is not dirty or clogged.
Do a check that the blade shaft rotates freely and no concrete has built up in the blade
block.
Do a check if there is fuel in the tank and it is the correct fuel. Make sure there is no
water in the fuel.
Do a check of the oil level. The engine has an oil alert system that stops the engine if
the oil level is too low.
Make sure that the air filter is not dirty or clogged.
Make sure that the spark plug is clean and has the correct gap, refer to the operator's
manual for the engine.
Make sure that the throttle control is set correctly.
Make sure that the choke is in the "ON" position for cold starts. Adjust the choke, refer
to the operator's manual for the engine.
Transportation, storage and disposal
Be careful during
Do not tow the product
•
Attach the product safely during transportation by
vehicle. Attach tie-down straps to the safety frame
and to the vehicle.
•
Remove the cutting blade before transportation of
the product.
•
Put the product in lower height position.
793 - 001 - 19.04.2022