Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Bending Instructions (cont'd)
Offsets
1. Measure the height and length of the obstruction.
Select the angle to be used.
2. See the Offset Table. The height of the obstruction
must be equal to or greater than the minimum
offset.
3. Refer to the X Table to find the X dimension. Refer
to the Offset Table to find the center-to-center
distance.
Note: If the center-to-center distance is not shown,
calculate it by using the multipliers shown in the
Offset Table.
4. Mark the conduit as shown.
5. Insert the conduit into the bender. Align Mark 1 with
the front edge of the hook and bend the conduit.
6. Align Mark 2 with the front edge of the hook.
Without removing the conduit from the bender,
rotate the conduit 180°. Make the second bend.
Offset Table
OFFSET
Max Conduit Size
15°
Center-to-Center
Max Conduit Size
30°
Center-to-Center
Max Conduit Size
45°
Center-to-Center
CENTER-TO-CENTER DISTANCE = OFFSET HEIGHT x MULTIPLIER
OFFSET ANGLE
10°
MULTIPLIER
5.8
Figures are approximate
X Table
CONDUIT SIZE
1/2
3/4
"X"
3-1/16
3-1/16
Figures are approximate
Greenlee Textron / Subsidiary of Textron Inc.
All manuals and user guides at all-guides.com
®
555
Deluxe Electric Bender
2
4
6
3/4
1-1/2
7-3/4
15-7/16
23-3/16
30-15/16
3/4
1
8
12
1/2
8-1/2
11-5/16
15°
22-1/2°
30°
3.9
2.6
2.0
1
1-1/4
1-1/2
3-3/16
4
4-1/4
LENGTH
MARK 1
HEIGHT
8
10
12
38-5/8
46-3/8
54-1/16 61-13/16
1-1/2
16
20
24
1
1-1/4
1-1/2
14-1/8
16-15/16 10-13/16
45°
1.4
2
4-1/2
14
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
X
CENTER TO CENTER
DISTANCE
LENGTH
OBSTRUCTION
14
16
18
20
2
69-9/16
77-1/4
2
28
32
36
40
2
22-5/8
25-7/16
28-1/4
MARK 2
22
85
44
31-1/8
Publicidad
Tabla de contenido
