Tramontina TRF25 Manual De Uso Y Mantenimiento página 21

Step 4 - assembling the switch
Remove the switch cover and attach the switch to the front of
the trestles using M4 x 10 mm screws and auto-locking M4 nuts.
Replace the switch cover [Fig. 04].
Step 5 - bending the hanging hooks
There are small tabs (A) on the shredder frame, [Fig. 05], which
you can pull out with a screwdriver so they can be used as
hooks (B), [Fig. 05] to hang a bag from. Insert a screwdriver in
the slit next to the tab and pull it out until the steel bends like
a hook (B), [Fig. 05].
Changing the tension for the models TRF25, TRE25, TRE30 and TRE40MA
First check the shredder tension and the local power network. Before changing the tension make sure
that the power cable is not plugged in. The tension selection switch is above the engine [Fig. 06].
Changing the tension for the model TRE40
The engines come without electrical connection. Connect the power according to the local mains
voltage. Before plugging the shredder into the mains supply, check the information on the tag that is
attached to the engine and the printed numbers on the electric cables [Fig. 07].
Fig. 06
21
Fig. 04
A B
Fig. 05
Fig. 07
EN