DeLonghi HSX4315E Manual De Instrucciones página 8

times, contact customer service.
Tipover safety device: This device turns the appliance
-
off if it falls over or is positioned inappropriately in such
a way as to jeopardize safety. The appliance emits a beep
and a dot flashes on the display. Few seconds after being
placed in upright position, the appliance will switch OFF.
Alarms
The appliance has a diagnostic system that makes it possible
to signal malfunctions.
In case of problems, the display will show an alarm message:
(Probe failure) and
troubleshooting section.
MAINTENANCE
Before carrying out any maintenance, unplug the heater
from the outlet and wait for it to cool off completely.
This heater requires no particular maintenance. It is
TROUBLESHOOTING
PROBLEM
The appliance doesn't work
The display shows a blinking dot and
you could hear a "beep"
The display shows "PF"
The display shows "Ht" blinking
(High temperature), see
CAUSE
Be sure it is plugged in and that the
electrical outlet is working
The temperature may be set too low
The Key lock may be activated
The appliance could be tipped over or is
positioned in an improper way
The temperature
malfunctioning
The internal temperature is too high.
sufficient to remove the dust with a soft, dry cloth.
Never use abrasive powders or solvents. If necessary
remove concentrated areas of dirt with a vacuum cleaner.
WARNING: any other servicing should be performed by an
authorized representative.
Should the heater not be in use over a certain length of time,
roll the cable around the feet and store it in a dry place.
Plug into the power outlet
Set the temperature to a higher
position
See the section "Key lock"
Make sure the appliance is standing
upright on a flat surface. Position the
appliance correctly
sensor is Contact the De longhi toll free number
Remove the plug from the mains.
Check the appliance is not covered
or obstructed. In case remove the
obstructions.
Check the appliance is correctly
positioned respecting the minimum
distance from the wall, or objects, as
indicated on the instruction manual,
if not, position the appliance correctly.
Let the appliance cool down and plug
the appliance again. If it doesn't work,
please contact the De longhi toll free
number
8
SOLUTION