INSTRUCTION MANUAL (Translation from the original Spanish)
Damage prevention and safety instructions
A Warning! Observe limitations of use.
B
The name plate voltage must be the same as the mains
voltage.
C
Connect the pump to the mains via an omnipolar switch
with at least a 1/8" opening between contacts.
Install a high-sensitivity differential switch (0.03A) as extra
protection against lethal electric shocks.
D
If the supply cord is damaged, it must be replaced by an
A.T.S.
E
Connect the pump to the ground.
F
Use pump only within performance limits indicated on the
name plate.
G
Remember to prime pump.
H
Check for motor self-ventilation.
I
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
Children should not perform the ordinary cleaning and
maintenance tasks without supervision.
J
Be careful with hazardous liquids and environments.
K
Caution! Look out for accidental leaks.
Do not expose pump to bad weather.
L
Caution! Avoid icing. Cut out power supply before
servicing pump.
8
EN
(See figure 4)