JMA EvoXpert Manual De Instrucciones página 28

After connecting to your EvoXpert machine, you just need to log-in using
your account details to perform any copying process, now with full access to
the calculation servers located at JMA.
4.3 MOBILE HOTSPOT WI-FI CONNECTION
Bearing in mind that the portable nature of EvoXpert means the machine can
be used on vehicles that are not located at your usual business premises,
the following settings will need to be configured in the Wi-Fi connections
section so that EvoXpert can be used in these conditions. This configuration
process is described below:
4.3.1 The easiest way to set up your connection for this
situation is by connecting to your business Wi-Fi network (in the example
above, that would be Perseo) and, before heading out to the vehicle to make
the copy, searching for your mobile Wi-Fi (in Hotspot Mode) to enter the
SSID and password of your mobile hotspot network.
28
After pressing CONNECT and waiting for your EvoXpert to restart (the Status
LED completes the Green-Red-Green cycle), you will have configured the
Wi-Fi connection on your EvoXpert to work with the Hotspot Wi-Fi network
on your mobile.
On some mobiles, you can check that this connection has been established
correctly by checking that the EvoXpert hostname (in this case, evoxpert-
C21C40) appears on the list of devices connected to the mobile Hotspot.
Having verified this step, the IP address that appears when clicking on
the hostname for the EvoXpert machine in connected devices (EVOXPERT-
C21C40 in this case, which translates to IP:192.168.43.202) can be used with
any browser on that mobile to access the web pages of the EvoXpert, with
an Internet connection obtained via the 4G/5G service on the customer's
mobile.
An easier way (as explained in Section 4.2.2.1) is by clicking on the JMA
KEY CLONING PRO app, finding your EvoXpert machine (to which you want
to connect) on the Wi-Fi HotSpot network created by your mobile and
connecting to it.
NOTE:
Before opening the JMA Key Cloning Pro app in HotSpot mode (shared
connection), we recommend disconnecting Wi-Fi on your mobile because, if
you scan with the two networks enabled at the same time, the app will find
your EvoXpert machine on the normal Wi-Fi network by default and not on
the HotSpot Wi-Fi network.
At this point, both the EvoXpert and the mobile could be switched off while
travelling and switched back on again when reaching the test location in the
following order: