Stocker E-200 LA Manual De Instrucciones página 106

11
Problems Cause
1. The battery is flat
2.The battery is not
connected
The chainsaw does not start
3.Trigger safety lock does
not release
4.Faulty switch
1. Loose internal
Intermittent operation connections
2.Faulty switch
1. Chain is not sharp or
damaged
Overheated chain or bar
2.Poor lubrication, resulting
in excessive friction
210
Art. 318
Chainsaw Magma E-200 LA
Troubleshooting
Solutions
1. Recharge the battery.
Instructions on page 195.
2.Check that the battery is
inserted correctly in the slot.
When positioned correctly,
you should hear a "click".
3. Replace the lock button
and/or trigger
4.Send to an authorised local
dealer or Stocker Srl.
1./2. Send to an authorised
local dealer or Stocker Srl.
1.Sharpen the chain or
replace it. Sharpening
instructions on page 206,
replacement instructions on
page 186.
2.Check correct chain
lubrication on page 204
3. Lubricate the chain.
Instructions on page 204.
Art. 318
Chainsaw Magma E-200 LA
Troubleshooting
Problems Cause
1.Poor lubrication,
resulting in excessive
friction
2.Chain and bar are dirty
Poor performance 3. The chain teeth are not
of the cut sharp
4.Imperfect technique
of the cut
5.Battery has not been
fully charged
1.The battery is not
properly positioned in the
charger
Battery is not charging.
2. The charger is not
The charger has a
properly connected to the
flashing red light.
mains
3.Battery charger
contacts are dirty
4.The battery or charger
is damaged or defective
For assistance and service, please contact your local dealer or Stocker S.r.l.
For further information about the product, please contact info@stockergarden.com
11
Solutions
1.Lubricate the chain. Instructions
on page 204.
2.Clean the teeth and the chain in
general. Instructions on page 202.
3.Sharpen the chain or replace it.
Sharpening instructions on page
206, replacement instructions on
page 186.
4.Carefully read the operating
instructions in the "Usage" section.
5.Check the battery charge level.
Instructions on page 199.
1.Check that the battery is inserted
correctly in the battery charger.
When positioned correctly, you
should hear a "click".
2.Connect correctly
3.Clean with a dry cloth
4.Try charging both batteries with
the charger. If only one of the two
batteries is recharged, the other
battery is damaged or defective. If
the charger does not charge any
of the batteries, it is damaged or
defective. Contact your local dealer
or Stocker srl to request spare parts.
211