Machine Information - VONROC S4 LM505DC Traducción Del Manual Original

Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use an extension
2
cable reel, always fully unroll the cable.

2. MACHINE INFORMATION

Intended use
This product is designed for lawnmowing in domestic
environments. The lawn mower is intended for pri-
vate gardens at home. The lawn mower may not be
used to trim bushes, hedges or shrubs, to cut scaling
vegetation, planted roofs, or balcony-grown grass,
to clean (vacuum) dirt and debris off walkways, or to
chop up tree or hedge clippings. Moreover, the lawn
mower may not be used as a power cultivator to level
out high areas such as molehills. The equipment is
to be used only for its prescribed purpose. Any other
use is deemed to be a case of misuse.
TECHNICAL SPECIFICATIONS
MACHINE
Model No.
Voltage
No load speed
Cutting width
Cutting height
Grass box capacity
Weight
Protection level
Sound pressure level (Lpa)
Sound power level (Lwa)
Vibration value
BATTERY
Model No.
Battery Type
Voltage
WWW.VONROC.COM
S4_LM505DC
40V (2 x 20V)
3500/min
380 mm
35/45/55/65mm
45 L
16,5 kg
IPX1
80.8dB(A), K=3dB(A)
91.4dB(A), K=2.29dB(A)
<2.5m/s², K=1.5m/s²
CD803AA
Lithium-Ion
20V
Capacity
Recommended charger
Weight
CHARGER
Model No.
Charger input
Charger output
Charging time 2Ah battery
Charging time 4Ah battery
Recommended batteries
Weight
Model No.
Charger input
Charger output
Charging time 2Ah battery
Charging time 4Ah battery
Recommended batteries
Weight
Only use the following batteries of the VONROC
VPOWER 20V battery platform. Using any other
batteries could cause serious injury or damage the
tool.
CD803AA 20V, 4Ah Lithium-Ion
The following chargers can be used to charge
these batteries.
CD802AA Quick charger
CD820AA Dual quick charger
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN 60335-1 and
EN 60335-2-77; it may be used to compare one
tool with another and as a preliminary assessment
of exposure to vibration when using the tool for the
applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
EN
4.0 Ah
CD802AA, CD820AA
0.65 kg
CD802AA
220-240V, 50Hz 0.4A
21V 2.5A
60 minutes
120 minutes
CD801AA, CD803AA
0.36 kg
CD820AA
220-240V, 50-60Hz,
200W
21V 2.3A, <3.8A
45 minutes
85 minutes
CD801AA, CD803AA
0.81 kg
13