Know Your Unit; Assembly Instructions - CubCadet HB226 Manual Del Operador

KNOW YOUR UNIT

APPLICATIONS
Cleaning yards, garages, driveways,
porches, patios, around walls,
fences and more
On/Off Stop Control
Cruise Control
Spark Plug
Blower Tube
Nozzle
4
Handle
Air Filter Cover
Trigger
Muffler
Cover
Blue Choke
Lever
Primer Bulb
Fuel Cap
ASSEMBLING UNIT
WARNING:
before removing or installing the blower tubes.
Starter
WARNING:
Rope Grip
tube must be installed while operating this unit.
Installing Blower Tube
1. Align the bump on the end of the blower tube with the bump slot on the bottom end of the blower outlet (Fig. 1).
2. Insert the bump on the blower tube into the bump slot on the blower outlet (Fig. 1).
3. Twist the blower tube clockwise inside the blower outlet until the bump locks into place (Fig. 2).
Blower
Outlet
Blower
Tube
Bump
Slot
Bump
Fig. 1
Installing Nozzle
1. Align the bump on the end of the blower tube with the bump slot on the top end of the nozzle (Fig. 3).
2. Insert the bump on the blower tube into the bump slot on the nozzle (Fig. 3).
3. Twist the nozzle clockwise over the blower tube until tight (Fig. 4).
Blower
Tube
Nozzle
Fig. 3
Removing the Blower Tube
1. Hold the unit firmly.
2. Insert a flathead screwdriver into the tube lock and twist the screwdriver counterclockwise 1/4 turn and hold
it there (Fig. 5).
3. While holding the screwdriver in a counterclockwise position, grasp the blower tube and twist it
counterclockwise (Fig. 5).
4. Pull the blower tube from the blower outlet.
Removing the Nozzle
1. Hold the blower tube firmly.
2. Grasp the nozzle and twist it counterclockwise until the nozzle unlocks from the blower tube (Fig. 6).
3. Remove the nozzle from the blower tube.
Tube Lock
Blower
Blower
Tube
Outlet
Fig. 5

ASSEMBLY INSTRUCTIONS

To avoid serious personal injury and damage to the unit, shut the unit off
To prevent serious personal injury or damage to the unit, the blower
Blower
Outlet
Blower
Tube
Nozzle
Bump
Bump
Slot
Nozzle
Fig. 2
Blower
Tube
Fig. 4
Blower
Tube
Fig. 6