Assembly - Shop-Vac SH Serie Manual Del Usuario

Ocultar thumbs Ver también para SH Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Set the tank upside down on
the floor. Set the caster feet at
approximately 45 degrees from
an imaginary line between the
inlet mounting and the handle
assembly. FIGURE 1.
FIGURE 1
4. Take caster foot marked with
the letter A and align as shown in
FIGURE 1. See FIGURE 2 for
caster foot marking.
5. Take caster foot marked with
the letter A and align arrow on
foot FIGURE 2, with arrow on
template also marked with the
letter A, FIGURE 3.
FIGURE 2
FIGURE 3
6. Place groove of foot over rim
of tank and push until the caster
foot is tight against bottom of
tank FIGURE 4.
FIGURE 4
7. Secure feet with screw and
washer when provided FIGURE 5.
8. If flatwashers are included in
hardware package place flatwasher
over stem of caster before
installing casters into feet. NOTE:
FIGURE 5
Flatwashers are not required with
all units.
9. Insert casters into feet by
placing stem of caster into holes
provided. Apply pressure and
twisting motion until casters snap
into place FIGURE 6.
FIGURE 6
10. Repeat steps 3-8 with
remaining feet.
11. With tank drain facing you,
attach hose holder A to caster foot
A, and hose holder B to caster
foot B.
FIGURE 7.
FIGURE 7
12. Apply pressure to front of hose
holder to snap into place.
FIGURE 8.
FIGURE 8
13. Return tank to upright position.
SIDE TANK HANDLE

ASSEMBLY

You will find a handle pack
containing two side tank handles
FIGURE 9, four handle supports
FIGURE 10 and four screws.
FIGURE 9
FIGURE 10
Assemble as follows:
14. Take two handle supports
and two 1" screws. Place screws
through the hole provided in center
of each support. FIGURE 11.
FIGURE 11
PAGE 5

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Sh14-c600

Tabla de contenido