Assembly - Shop-Vac E4 Serie Manual Del Usuario

8. Plug the cord into the wall outlet. Your cleaner is
ready for use.
I = ON, O = OFF
NOTE: MANY MORE USEFUL TOOLS ARE
AVAILABLE AT YOUR LOCAL DEALER OR SHOP-
VAC WEBSITE
®
REAR WHEEL AND
FRONT CASTER

ASSEMBLY

FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 5
PAGE 5
You will find two casters.
FIGURE 2
Two axle housings.
FIGURE 3.
Two wheel plugs.
FIGURE 4.
Two wheels and two screws.
FIGURE 5.
FIGURE 6
FIGURE 7
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 11
9. With cord disconnected
from receptacle and tank
cover removed, turn tank
upside down so that the
bottom is facing up with the
inlet towards you.
FIGURE 6.
10. Insert caster into bottom
of tank by placing stem of
caster into holes provided.
Apply pressure and twisting
motion until casters snap into
place. FIGURE 7.
11. Insert axle housing into
wheel, with the longer end
of the housing facing up.
FIGURE 8.
12. Insert wheel plug (with
tab in upward position)
through wheel and axle
housing aligning the tab on
the plug with the slot in the
axle housing. FIGURE 9.
13. Place assembled wheel
on hard flat surface. Apply
pressure to snap assembly
together. FIGURE 10.
14. Insert screw provided
through back of axle housing.
FIGURE 11.