Functions; Operating Display - auna C500 Manual De Instrucciones

EN
32
Assembly
Place the box where you want to mount it and mark the four drill holes on
the mounting board (not included). Drill holes with a diameter of approx. 3
mm. Screw the device on with the enclosed screws (15 mm). Make sure that
the board is at least 15 mm thick.
Note: Tighten the screws firmly but do not use too much force. The
torque should be less than 1 Nm.

FUNCTIONS

Operating display

1
Lights up green during operation.
Protection control lamp
Overvoltage: lights up red in case of overvoltage or short circuit
2
Offset: lights up when the voltage to the speaker terminals is too
high.
Thermal: lights up when the temperature is too high.
Filter selector switch
3
When the switch is set to LPF, the filter is set to low pass. When
the switch is set to HPF, the filter is set to high-pass.